Сервера IBM и SYSTEM MGNT интерфейс (IMM)

Можно бутить, включать, выключать.

Enabling the remote presence feature To enable the remote presence feature, complete the following steps: 1.Install the virtual media key into the dedicated slot on the system board (see “System-board optional device connectors” on page 38). 2.Turn on the server. Note:Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button becomes active. Obtaining the IP address for the IMM To access the Web interface, you need the IP address for the IMM. You can obtain
the IMM IP address through the Setup utility. The server comes with a default IP
address for the IMM of 192.168.70.125. To locate the IP address, complete the
following steps:
1.Turn on the server. Note:Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button becomes active. Chapter 3. Configuring the server 93

2.When the prompt Setup is displayed, press F1. (This prompt is displayed on the screen for only a few seconds. You must press F1 quickly.) If you have set both a power-on password and an administrator password, you must type the administrator password to access the full Setup utility menu.
3.From the Setup utility main menu, selectSystem Settings.
4.On the next screen, selectIntegrated Management Module.
5.On the next screen, selectNetwork Configuration.
6.Find the IP address and write it down.
7.Exit from the Setup utility.
Logging on to the Web interface To log on to the Web interface to use the remote presence functions, complete the following steps: 1.Open a Web browser and in theaddress orURL field, type the IP address or host name of the IMM to which you want to connect. Note:The IMM defaults to DHCP. If a DHCP host is not available, the IMM assigns a static IP address of 192.168.70.125. 2.On the Login page, type the user name and password. If you are using the IMM for the first time, you can obtain the user name and password from your system administrator. All login attempts are documented in the event log. Note:The IMM is set initially with a user name of USERID and password of PASSW0RD (passw0rd with a zero, not a the letter O). You have
read/write access. You must change the default password the first time
you log on.
3.On the Welcome page, type a timeout value (in minutes) in the field that is
provided. The IMM will log you off of the Web interface if your browser is
inactive for the number of minutes that you entered for the timeout value.
4.ClickContinue to start the session. The System Health page provides a quick view of the system status.